PRODUCT DISCRIPTION:
| Surfaces | GRP, laminates, steel, aluminum | |
| Area | Above and below waterline | |
| Function | Grounding Intercoating Filling Antiosmotic Anticorosive | |
| Application | spray can | |
| Theoretical coverage for 400 ml | 1-2 м2 | |
| Number of coats | 2 – 4 | |
| Pot life 20°C | 48 h | |
| Time between layers without sanding | 5~10 minutes | |
| Color (matt) | white | |
| Pack | 400 ml | |
| Code | 38758 | |
Before triggering, shake can thoroughly for 2 minutes after agitation balls are heard.
Remove the red pushbutton from the cap.
Turn the can by 180° and fit the pushbutton onto the pin in the base of the can.
Turn the can upside down and place on a firm surface.
Press the red pushbutton all the way in with the palm of your hand.
After triggering, shake can again thoroughly for 2 minutes after agitation balls are heard.
Set the adjustable spray nozzle to the size of the damage and damage pattern.
Spray distance: 10 ~ 20cm.
Standard application: approx. 2÷4 spray coats, recommended dry film layer: 80 ~200 μm
NOTICE: For antiosmosis and anticorrosion protection recommended DTF is 240 μm.
Allow a flash-off time of approx. 5-10 minutes between spray coats.
After painting, turn the can upside down and spray the valve until empty.
The completely empty spray cans can be disposed of in the recycling waste container.
Cans with hardened material must be disposed of as special waste.
MASKING TAPE MASKING TAPE – MASTER “AQUA” SILVER TAPE – UNIVERSAL MASKING TAPE High-quality masking tape characterized by very good adhesion […]
DUST MASK DISPOSABLE NITRILE GLOVES “MASTER” DISPOSABLE NITRILE GLOVES WORKWEAR – SINGLE USE POLYESTER WORKWEAR (blue) reusable overall PASTE HAND […]
It is very important to use paint thinners, which provide the appropriate parameters of paint – flow, pot life, time […]
CORK SANDING BLOCK FOAM SANDING BLOCK PLASTIC SANDING BLOCK PROTECTIVE FOIL PAPER TOWEL (ROLL) ANTISTATIC RAGS CORK SANDING BLOCK Sanding […]
UNIVERSAL YACHT PRIMER 1K 1-component chlorinated rubber primer Recommended above and under the water line It can be use on […]
Thinner for all Sea-Line epoxy primers. It is very important to use paint thinners, which provide the appropriate parameters of […]
We do not recommend using universal thinners. The use of a thinner with an unknown composition may result in loss of adhesion, lack of proper flow of paint and varnish defects.
If the scratches are not deep, then we can renew the scratched side by polishing with Sea-Line polishing pastes. Above the waterline, when the scratches are not deep, the surface can be repaired with a DRY FAST gel coat filler. Deep scratches should be filled with epoxy filler (selected depending on the requirements of the scratched surface), painted with a primer and then painted with topcoat.
Refilling and to tackle inequalities caused by damage to or during the course of production
Protects boat surfaces from the effects of destructive activities osmosis and corrosion
Provide an aesthetic and a perfect look of the boat also protective against water and UV radiation
Protect the hull from fouling with algae and shells
Effectively remove scratches, refresh the color of gelcoat or paint, fast shine effect
Special preparations for effective cleaning and refinishing
Laminating, gluing and filling in cracks in gelcoat
Range of products useful in the boat builder work
