Language:

NEW OFFER! Antifouling for aluminium

Home » News and promotions » NEW OFFER! Antifouling for aluminium
Zabezpieczenie łodzi
NEW OFFER! Antifouling for aluminium

NEW OFFER! Selfpolishing Antifouling for aluminium boats.
Recommended for salty and sweet water.
It is suitable for sailing and motor boats up to speed to 40 knots.
Recommended to protect areas below the water line. Suitable for all kind of boats up to 40 knots of speed.
Extremely effective, very high performance
It can be applied on:

No risk of galvanic corrosion on aluminium surfaces.Paint is composed of copper oxide and resins. It does not contain tin compounds.
Performance 12 m2 per liter for coat 50μm. Can 0,75 l and 2,5 l.


Share:

See also
Other threads in this category

Our FAQ
Answers to frequently asked questions

Why the epoxy filler does not harden?

Possible causes

  • Incorrect proportion of base and herdener,
  • Too low temperature of ambient and surface (less than 10ﹾC),
  • Mixing two components from two different manufacturers,

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
  • Use base and hardener from the same manufacturer

How to remove

  • The uncured mass requires complete removal from the surface.

Why the paint does not have the right flow?

Possible causes

  • No thinning, wrong thinner or wrong amount of thinner
  • Wrong type of roll or brush (wrong bristle lenght)
  • Applying too much or too Little paint,
  • During painting process temperature was too high or the air was too dry,
  • Incorrect preparation of too porous surface,
  • Incorrect proportion of thinner.

How to prevent

  • Use a brush/Toller suited to the type of surface or paint,
  • Use thinner which is dedicated to the type of application and paints
  • Use thinning proportions which was indicated by manufacturer,
  • Paint in right atmosphere conditions indicated by manufacturer,

How to remove

  • Grind, clean and paint again.

Why despite the use of antifouing paint the bottom of the boat is overgrown?

Possible causes

  • Too thin layer of antifouling paint,
  • Choosing the wrong antifouling to type of a boat or yacht
  • Thinning of antifouling paint,
  • Incorrect surface preparation before antifouling application.

How to prevent

  • Apply the right layer thickness of paint indicated by manufacturer,
  • Choose antifouling dedicated to type of boat or yacht and suitable for the type of water,
  • Do not thin antifouling because of the risk of reducing effectiveness,
  • Careful surface preparations (grinding, clearing, degreasing),

How to remove

  • Wet grinding, apply new layers of antifouling paint.
  • Use C1 shell and fouling remover.
Our offer
Familiarize yourself with our offer of boatbuilding materials and paints
Exit
Przewiń na górę