Lengua:

11 months on Mediterranean Sea (Barcelona)

Página web » Críticas » 11 months on Mediterranean Sea (Barcelona)
Kosmetyki do naprawy łodzi oraz jachtów
11 months on Mediterranean Sea (Barcelona)

«Overall I’m pleased with the antifouling action. It is true that I do not have too much comparison, because this is my first boat and the first paint.

The whole weed descended without major problems Karcher (weak). Most overgrown with water line from the more sunny and rudder blade. On the upper edge of the even appeared crustaceans. It is the only place around the hull where they were. »

Bartosz Szymanski, Yacht SASHQA

Photos bottom after 11 months in the Mediterranean Sea


Compartir:

Ver también
Otros hilos de esta categoría

Nuestras FAQ
Respuestas a las preguntas más frecuentes

Why despite the use of antifouing paint the bottom of the boat is overgrown?

Possible causes

  • Too thin layer of antifouling paint,
  • Choosing the wrong antifouling to type of a boat or yacht
  • Thinning of antifouling paint,
  • Incorrect surface preparation before antifouling application.

How to prevent

  • Apply the right layer thickness of paint indicated by manufacturer,
  • Choose antifouling dedicated to type of boat or yacht and suitable for the type of water,
  • Do not thin antifouling because of the risk of reducing effectiveness,
  • Careful surface preparations (grinding, clearing, degreasing),

How to remove

  • Wet grinding, apply new layers of antifouling paint.
  • Use C1 shell and fouling remover.

Why the epoxy filler does not harden?

Possible causes

  • Incorrect proportion of base and herdener,
  • Too low temperature of ambient and surface (less than 10ﹾC),
  • Mixing two components from two different manufacturers,

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
  • Use base and hardener from the same manufacturer

How to remove

  • The uncured mass requires complete removal from the surface.

Why are the streaks formed?

Possible causes

  • Wrong viscosity and spraying technique,
  • Failure to maintain proper evaporation time and thickness of layers,
  • Incorrect spraying pressure,
  • Too low temperature of varnish, surface or space ,
  • Wrong thinner or hardener.

How to prevent

  • Apply the right type of application method indicated by manufacturer,
  • Use working spray guns,
  • Both the object and material must have room temperature of 20ﹾC,
  • Apply correct proportion of base and hardener.

How to remove

  • Grinding and polishing,
  • Grinding and painting,
Nuestra oferta
Consulte nuestra oferta de materiales y pinturas para la construcción de embarcaciones
Exit
Przewiń na górę