Γλώσσα:

SEAGUARD fouling stop bottom paint

Ιστοσελίδα » Νέα και προσφορές » SEAGUARD fouling stop bottom paint
Farby dla jachtów
SEAGUARD fouling stop bottom paint

SEAGUARD FOULING STOP – a new anti-fouling paint for hulls.

Contrary to the traditional anti-fouling paints, SEAGUARD does not contain active ingredients, i.e. toxic biocides. The bottom paint is much more environmentally friendly, which is significant especially in the case of such reservoirs as lakes. It can also be used for fresh waters, coastal waters and salt waters. Modern solutions were applied in producing this paint which allowed to create a coating which will make it more difficult for lichens to maintain and develop on a surface. Sea-Line Seaguard works best for units moving with the speed not higher than of 30 knots and which are used often.

SEAGUARD is a self-polishing paint which is an extra benefit for users. It can be used for all types of yachts and boats – laminate, wood, steel and aluminium. It is available in 0,75 l and 2,5 l containers, navy blue and white colours. SEAGUARD is a paint which can safely be applied with air spraying and its advantage is high capability – up to 10m2 out of 1 litre.

The product was designed in view of the countries where anti-fouling varnishes containing biocides are forbidden and recalled. SEAGUARD FOULING STOP is compatible with the majority of available anti-fouling products and will be available from 10th March 2016.


Μετοχή:

Δείτε επίσης
Άλλα νήματα σε αυτήν την κατηγορία

Οι συχνές ερωτήσεις μας
Απαντήσεις σε συνήθεις ερωτήσεις

Can I paint a boat, previously painted with 1 component paint, with polyurethane?

No, polyurethane is a 2-component paint (base + hardener) and after applying 2-component paint to 1-component paint, the proper adhesion of the paint to the surface will not be maintained, the paint will begin to wrinkle and surface defects will appear.

Why the epoxy filler does not harden?

Possible causes

  • Incorrect proportion of base and herdener,
  • Too low temperature of ambient and surface (less than 10ﹾC),
  • Mixing two components from two different manufacturers,

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
  • Use base and hardener from the same manufacturer

How to remove

  • The uncured mass requires complete removal from the surface.

Is it necessary to always sand the surface between application of two different products?

We recommend to always sand the surface between applying two different products to ensure uniform surface roughness and adhesion of subsequent layers. The sanded surface should also be cleaned and degreased.

Η προσφορά μας
Εξοικειωθείτε με την προσφορά μας σε υλικά και χρώματα ναυπήγησης σκαφών
Exit
Przewiń na górę