Γλώσσα:

11 months on Mediterranean Sea

Ιστοσελίδα » Κριτικές » 11 months on Mediterranean Sea
Farby szkutnicze
11 months on Mediterranean Sea

“Overall I’m pleased with the antifouling action. It is true that I do not have too much comparison, because this is my first boat and the first paint.

The whole weed descended without major problems Karcher (weak). Most overgrown with water line from the more sunny and rudder blade. On the upper edge of the even appeared crustaceans. It is the only place around the hull where they were. ”

Bartosz Szymanski, Yacht SASHQA

Photos bottom after 11 months in the Mediterranean Sea


Μετοχή:

Δείτε επίσης
Άλλα νήματα σε αυτήν την κατηγορία

Οι συχνές ερωτήσεις μας
Απαντήσεις σε συνήθεις ερωτήσεις

Why the resin does not harden?

Possible causes

  • Too low temperature of ambitne,
  • Incorrect proportion of base and herdener,
  • Mixing two components from two different manufacturers

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during whole hardening process,
  • Mix the products thoroughly and bleed the mixture.

How to remove

  • The uncured mass requires complete removal from the surface.

Why does the paint have no adhesion?

Possible causes

  • Wrong surface preparation,
  • Skipping the primer in the system application process,
  • Use of universal thinners or replacements ,
  • Paint incompatibility.

How to prevent

  • Correct surface preparation (grinding, clearing, degreasing),
  • Use primers which improve adhesion of paints,
  • Use thinners which are dedicated to each paints,
  • Use of paints which are compatible to each other.

How to remove

  • Grind, clean and paint again.

Why the epoxy filler does not harden?

Possible causes

  • Incorrect proportion of base and herdener,
  • Too low temperature of ambient and surface (less than 10ﹾC),
  • Mixing two components from two different manufacturers,

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
  • Use base and hardener from the same manufacturer

How to remove

  • The uncured mass requires complete removal from the surface.
Η προσφορά μας
Εξοικειωθείτε με την προσφορά μας σε υλικά και χρώματα ναυπήγησης σκαφών
Exit
Przewiń na górę