Langue:

Primaire époxydique Lightprimer 5:1

Accueil » Produits » Primaires » Primaire époxydique Lightprimer 5:1
Farby dla jachtów
Primaire époxydique Lightprimer 5:1


Type de bateauGRP laminates, l’bois
EndroitAu dessous et au dessus de la ligne de flottaison
FunctionDe fond
Entre couches
Remplissant
Anti-osmose
ApplicationPinceau, rouleau, projection
DilutionOui – dilutif pour les systèmes époxydiques
Rendement théorétique pour 1l11-10 m2 pour: 90 μm WFT / 60 μm DFT
Nombre de couches1 – 5
Temps de travail 20°C2 h
Temps entre les couches Sans la nécessité de ponçageMini 4h
Maxi 5 jours
Emballagecodes
CouleurBlancGris
0,750l –
3,0l –
5,0l –
15 l –		5077
8388
6093
6092		9200
9199
X
1312

Epoxy PrimerLightprimermanualapplication:

ROLLER / BRUSH



SPRAY




Partager:

Avez-vous des questions?
Nous vous répondrons dans les plus brefs délais

Produits connexes

de Primaire époxydique Lightprimer 5:1


Voir aussi
Autres produits de cette catégorie

Notre FAQ
Réponses aux questions fréquemment posées

Why the paint does not have the right flow?

Possible causes

  • No thinning, wrong thinner or wrong amount of thinner
  • Wrong type of roll or brush (wrong bristle lenght)
  • Applying too much or too Little paint,
  • During painting process temperature was too high or the air was too dry,
  • Incorrect preparation of too porous surface,
  • Incorrect proportion of thinner.

How to prevent

  • Use a brush/Toller suited to the type of surface or paint,
  • Use thinner which is dedicated to the type of application and paints
  • Use thinning proportions which was indicated by manufacturer,
  • Paint in right atmosphere conditions indicated by manufacturer,

How to remove

  • Grind, clean and paint again.

Why despite the use of antifouing paint the bottom of the boat is overgrown?

Possible causes

  • Too thin layer of antifouling paint,
  • Choosing the wrong antifouling to type of a boat or yacht
  • Thinning of antifouling paint,
  • Incorrect surface preparation before antifouling application.

How to prevent

  • Apply the right layer thickness of paint indicated by manufacturer,
  • Choose antifouling dedicated to type of boat or yacht and suitable for the type of water,
  • Do not thin antifouling because of the risk of reducing effectiveness,
  • Careful surface preparations (grinding, clearing, degreasing),

How to remove

  • Wet grinding, apply new layers of antifouling paint.
  • Use C1 shell and fouling remover.

Why the resin does not harden?

Possible causes

  • Too low temperature of ambitne,
  • Incorrect proportion of base and herdener,
  • Mixing two components from two different manufacturers

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during whole hardening process,
  • Mix the products thoroughly and bleed the mixture.

How to remove

  • The uncured mass requires complete removal from the surface.
Notre offre
Familiarisez-vous avec notre offre de matériaux et de peintures pour la construction de bateaux
Exit
Przewiń na górę