Micro Spark 550 – overhaul

Possible causes

• Wrong viscosity and spraying technique,
• Failure to maintain proper evaporation time and thickness of layers,
• Incorrect spraying pressure,
• Too low temperature of varnish, surface or space ,
• Wrong thinner or hardener.

How to prevent

• Apply the right type of application method indicated by manufacturer,
• Use working spray guns,
• Both the object and material must have room temperature of 20ﹾC,
• Apply correct proportion of base and hardener.

How to remove

• Grinding and polishing,
• Grinding and painting,

Possible causes

• No thinning, wrong thinner or wrong amount of thinner
• Wrong type of roll or brush (wrong bristle lenght)
• Applying too much or too Little paint,
• During painting process temperature was too high or the air was too dry,
• Incorrect preparation of too porous surface,
• Incorrect proportion of thinner.

How to prevent

• Use a brush/Toller suited to the type of surface or paint,
• Use thinner which is dedicated to the type of application and paints
• Use thinning proportions which was indicated by manufacturer,
• Paint in right atmosphere conditions indicated by manufacturer,

How to remove

• Grind, clean and paint again.

Do not add more hardener, because after the base has cured, the remaining hardener will react with subsequent layers, which will be applied to the surface and cause defects. For the product to work properly, please follow the proportions given by the manufacturer.