Parafina Sea-Line

Paraffin is an additive mainly to polyester gelcoats, necessary when it is necessary to apply the gelcoat to the outer surface of the finished laminate.

Gelcoat with the addition of paraffin corrector is topcot. By adding paraffin to the gelcoat, we will stop the phenomenon of oxygen inhibition, which is the reason why the gelcoat does not dry out and the surface remains sticky.

Capacity	Code
60ml	300010264

Technical informations

Safety data sheet SDS

Product description "Parafina Sea-Line"

Recommended amount of paraffin 2%-5%.
Mixing proportions of ingredients: gelcoat: hardener: paraffin 100:3:2-5

Always remember about health and safety.

Before working with chemical products, make sure you have read the SDS and TDS.
Use protective gloves, eye/face protection when handling the product, and wear a mask if instructed to do so.
Store the product in a tightly closed container at room temperature (15-25°C).
Protect from sunlight and frost.

Also check

Lamination – fiberglass and glassfabric
Fiberglass reinforcements, including boat mats and fiberglass fabrics combined with resin, are used for repairs
Lamination – fiberglass and glassfabric
Polymer
Is elastic sealant recommended for sealing and bonding various types of materials.
Polymer
Non Skid Powder
Non skid powder is anadditive for polyurethane topcoats. Non-slip powder = 20 grams, the amount
Non Skid Powder

Our FAQ answers to frequently asked questions

Possible causes

Incorrect proportion of base and herdener,
Too low temperature of ambient and surface (less than 10ﹾC),
Mixing two components from two different manufacturers,

How to prevent

Apply the correct proportions of components
Maintain steady temperature (around 20ﹾC) during the whole hardening process,
Use base and hardener from the same manufacturer

How to remove

The uncured mass requires complete removal from the surface.

Possible causes

Too low temperature of ambitne,
Incorrect proportion of base and herdener,
Mixing two components from two different manufacturers

How to prevent

Apply the correct proportions of components
Maintain steady temperature (around 20ﹾC) during whole hardening process,
Mix the products thoroughly and bleed the mixture.

How to remove

The uncured mass requires complete removal from the surface.

There is a possibility of thinning antifouling, but we do not recommend this procedure due to the risk of reducing the effectiveness of the paint. If it is necessary to thin the antifouling paint, it is recommended to dilute it to a maximum of 0-5% (by volume).