Wyszukaj na stronie
Menu

Polishing sponge “M14”

Polishing Sponge available in four hardnesses, with plastic handle, the handle terminates in a finial cap, which allows easy and stable assembly / disassembly polishing sponge.

SizeColorRecommended backing plateCode
∅ 150 mmwhiteKits included (M14)300000376
∅ 150 mmorangeKits included (M14)300000377
∅ 150 mmyellowKits included (M14)300000378
∅ 150 mmblackKits included (M14)300000379
Polishing sponge “M14”
  • Cut level - white = 9
  • Cut level - orange = 7
  • Cut level - yellow = 4
  • Cut level - black = 2

You have questions about the product - Polishing sponge “M14”

    Also check

    Our FAQ answers to frequently asked questions

    Why the epoxy filler does not harden?

    Possible causes

    • Incorrect proportion of base and herdener,
    • Too low temperature of ambient and surface (less than 10ﹾC),
    • Mixing two components from two different manufacturers,

    How to prevent

    • Apply the correct proportions of components
    • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
    • Use base and hardener from the same manufacturer

    How to remove

    • The uncured mass requires complete removal from the surface.

    Can I use universal thinner?

    We do not recommend using universal thinners. The use of a thinner with an unknown composition may result in loss of adhesion, lack of proper flow of paint and varnish defects.

    Do you have to paint the scratched side of the boat?

    If the scratches are not deep, then we can renew the scratched side by polishing with Sea-Line polishing pastes. Above the waterline, when the scratches are not deep, the surface can be repaired with a DRY FAST gel coat filler. Deep scratches should be filled with epoxy filler (selected depending on the requirements of the scratched surface), painted with a primer and then painted with topcoat.

    Wyjście
    Przeiń na górę