Recommendation for LIGHTWEIGHT EPOXY FILLER – Sea Line

Lightweight epoxy filler Sea-Line was used also in our last custom sailing boat – catamaran Wave 58.

It’s very good material to finishing aluminum and composite structure. During few years of testing and using Sea Lines product we don’t have any complaint.

Bartosz Puchowski

www.creeyacht.pl

Rekomendowana szpachlowka epoksydowa lekka Sea Line

Do you have questions about "Recommendation for LIGHTWEIGHT EPOXY FILLER – Sea Line"

Also check

Sensational Bandzior
Renovation of the Spanish motorboat Ducauto caribe. “Cut in half, gutted and made according to
Sensational Bandzior
Cosmetics Sea-Line in Polish Army
Cosmetics Sea-Line use in Polish Army for cleaning and protect Sea Gun AM35 on „ORP
Cosmetics Sea-Line in Polish Army
Disco Volante – Wojciech Cieślik
Mr. Wojciech Ceiślik, boatbuilder Glen-L Squirt: „I recommend Sea-Line products to everyone who builds and
Disco Volante – Wojciech Cieślik
MAK 707
„… It was not easy, hard job on knees with mask and glasses. Feeling like
MAK 707

Our FAQ answers to frequently asked questions

Possible causes

Incorrect proportion of base and herdener,
Too low temperature of ambient and surface (less than 10ﹾC),
Mixing two components from two different manufacturers,

How to prevent

Apply the correct proportions of components
Maintain steady temperature (around 20ﹾC) during the whole hardening process,
Use base and hardener from the same manufacturer

How to remove

The uncured mass requires complete removal from the surface.

Possible causes

Too thin layer of antifouling paint,
Choosing the wrong antifouling to type of a boat or yacht
Thinning of antifouling paint,
Incorrect surface preparation before antifouling application.

How to prevent

Apply the right layer thickness of paint indicated by manufacturer,
Choose antifouling dedicated to type of boat or yacht and suitable for the type of water,
Do not thin antifouling because of the risk of reducing effectiveness,
Careful surface preparations (grinding, clearing, degreasing),

How to remove

Wet grinding, apply new layers of antifouling paint.
Use C1 shell and fouling remover.

There is a possibility of thinning antifouling, but we do not recommend this procedure due to the risk of reducing the effectiveness of the paint. If it is necessary to thin the antifouling paint, it is recommended to dilute it to a maximum of 0-5% (by volume).