Wyszukaj na stronie

Excellent paint Sea-Line

“Excellent paint may perhaps even better than other well-known brands. Very readable and clear documentation. Ease of application (…). Antifouling not lose its properties over time until it is completely selfpolished. Support available by phone. (..)

If someone asks me to choose paint I show him the bottom of our boat and recommend the Sea-line brand”

Excellent paint Sea-Line

Doskonale farby Sea Line

Doskonale farby Sea Line

Doskonale farby Sea Line

Doskonale farby Sea Line

Doskonale farby Sea Line

Do you have questions about "Excellent paint Sea-Line"

    Also check

    Our FAQ answers to frequently asked questions

    Why the paint does not have the right flow?

    Possible causes

    • No thinning, wrong thinner or wrong amount of thinner
    • Wrong type of roll or brush (wrong bristle lenght)
    • Applying too much or too Little paint,
    • During painting process temperature was too high or the air was too dry,
    • Incorrect preparation of too porous surface,
    • Incorrect proportion of thinner.

    How to prevent

    • Use a brush/Toller suited to the type of surface or paint,
    • Use thinner which is dedicated to the type of application and paints
    • Use thinning proportions which was indicated by manufacturer,
    • Paint in right atmosphere conditions indicated by manufacturer,

    How to remove

    • Grind, clean and paint again.

    Why did the polyurethane topcoat become dull?

    Possible causes

    • Too short time for evaporation of the thinner,

    How to prevent

    • Maintain the right conditions for complete evaporation of the thinner,

    How to remove

    • Mat the surface, degrease and apply the paint according to the rule (right conditions and thinning proportions)
    • Polish surface if needed.

    Why the resin does not harden?

    Possible causes

    • Too low temperature of ambitne,
    • Incorrect proportion of base and herdener,
    • Mixing two components from two different manufacturers

    How to prevent

    • Apply the correct proportions of components
    • Maintain steady temperature (around 20ﹾC) during whole hardening process,
    • Mix the products thoroughly and bleed the mixture.

    How to remove

    • The uncured mass requires complete removal from the surface.
    Wyjście
    Przeiń na górę