Wyszukaj na stronie
Menu

C1 Bottom Cleaner

C1 BOTTOM CLEANER is a powerful, effective formula to rapidly remove dirt, rests of shells from boat hull.

CapacityCode
500 ml300006978
C1 Bottom Cleaner

Technical informations

Color

  • brown (transparent)

Application method

Manually:

  • atomizer (included)

Product description "C1 Bottom Cleaner"

C1 Bottom Cleaner is an economical, efficient, and strong, very effective product for independent use in removing dirt and residues from the surface of the boat’s bottom:

  • algae
  • seaweed
  • shells
  • barnacles

Thanks to the modern formula, the cleaning effects of the product are visible a few minutes after application.

Consistency:

  • Liquid

Odour:

  • Acre

Solubility in water:

  • 100%

PH at 20°C:

  • <1 (contains acids – see MSDS)

Surface preparation

  • Clean the surface with water to remove dirt.
  • Apply in small quantity on the surface and leave for 5 to 15 minutes.
  • Remove the dirt and treated with a fresh water under pressure or use a sponge kitchen with plenty of rinsing with water.

In cases of very heavy dirt, can re-apply product and remove it after approximately 10 minutes.

NOTE:

When using C1 SUPER STRONG, wear personal protective equipment, such as:

  • protective clothing,
  • goggles,
  • gloves

You have questions about the product - C1 Bottom Cleaner

    Also check

    Our FAQ answers to frequently asked questions

    Can I use selfpolishing Sea-Line and HARD Sea-Line antifoulings on aluminium boat?

    Sea-Line HARD and Sea-Line self-polishing antifouling are not intended for aluminum surfaces. They include copper oxide, which in contact with aluminum causes galvanic corrosion. Especially on aluminum, we offer ALU-PLUS self-polishing anti-fouling paint, which, in addition to excellent adhesion to aluminum, is also 30% more effective than traditional anti-fouling paints.

    Can I purchase products directly from you?

    We do not sell retail. Our products can be found in many stores in Poland and abroad. Our distributors run stationary and online stores. The full list of distributors and contacts can be found on our website at the following link click here.

    Why the epoxy filler does not harden?

    Possible causes

    • Incorrect proportion of base and herdener,
    • Too low temperature of ambient and surface (less than 10ﹾC),
    • Mixing two components from two different manufacturers,

    How to prevent

    • Apply the correct proportions of components
    • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
    • Use base and hardener from the same manufacturer

    How to remove

    • The uncured mass requires complete removal from the surface.
    Wyjście
    Przeiń na górę