Wyszukaj na stronie

Warsow Yacht Salon

We would like to invite you to the Warsaw Yacht Salon and meet our representatives. This is an excellent opportunity to talk about possible options for yacht renovation or refit your boat. We also plan to conduct gelcoat and varnish polishing demonstrations during which we will answer all your questions. We have prepared discount coupons for all our guests, which can be used when shopping in the best yachting stores.

In addition, we will share information about new products that may surprise you a lot. How about choosing one of 17,000 colors for your boat?

The event takes place at Ptak Warsaw Expo on November 5-7. Our booth number is 5.113.

Warsow Yacht Salon

Also check

Our FAQ answers to frequently asked questions

Contamination in topcoat paint?

Possible causes

  • Inaccurate surface cleaning before paint application,
  • Incorrect painting tools preparation (brush and roll),
  • Performing work in a place exposed to constant contact with dust.

How to prevent

  • Careful surface preparation (grinding, clearing, degreasing),
  • Careful painting tools preparation before use,
  • Maintain clean work environment

How to remove

  • Grind, clean and paint again.

Can I use selfpolishing Sea-Line and HARD Sea-Line antifoulings on aluminium boat?

Sea-Line HARD and Sea-Line self-polishing antifouling are not intended for aluminum surfaces. They include copper oxide, which in contact with aluminum causes galvanic corrosion. Especially on aluminum, we offer ALU-PLUS self-polishing anti-fouling paint, which, in addition to excellent adhesion to aluminum, is also 30% more effective than traditional anti-fouling paints.

Why are the streaks formed?

Possible causes

  • Wrong viscosity and spraying technique,
  • Failure to maintain proper evaporation time and thickness of layers,
  • Incorrect spraying pressure,
  • Too low temperature of varnish, surface or space ,
  • Wrong thinner or hardener.

How to prevent

  • Apply the right type of application method indicated by manufacturer,
  • Use working spray guns,
  • Both the object and material must have room temperature of 20ﹾC,
  • Apply correct proportion of base and hardener.

How to remove

  • Grinding and polishing,
  • Grinding and painting,
Wyjście
Przeiń na górę