Wyszukaj na stronie

NEW! Polyester spray filler

Sea-Line Offerhas been extended with a new polyestersprayfiller.

  • two componentpoyester spray filler.
  • recommended for priming fibregras reinfoced hulls and other GFK surfaces.
  • for filling small cracks and indentations before painting.
  • finishing layer other polyester surfaces (putties, fillers, laminates).
NEW! Polyester spray filler

Also check

Our FAQ answers to frequently asked questions

Can I add more hardener to speed up the reaction?

Do not add more hardener, because after the base has cured, the remaining hardener will react with subsequent layers, which will be applied to the surface and cause defects. For the product to work properly, please follow the proportions given by the manufacturer.

Why the resin does not harden?

Possible causes

  • Too low temperature of ambitne,
  • Incorrect proportion of base and herdener,
  • Mixing two components from two different manufacturers

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during whole hardening process,
  • Mix the products thoroughly and bleed the mixture.

How to remove

  • The uncured mass requires complete removal from the surface.

Why the epoxy filler does not harden?

Possible causes

  • Incorrect proportion of base and herdener,
  • Too low temperature of ambient and surface (less than 10ﹾC),
  • Mixing two components from two different manufacturers,

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
  • Use base and hardener from the same manufacturer

How to remove

  • The uncured mass requires complete removal from the surface.
Wyjście
Przeiń na górę