Wyszukaj na stronie
Menu

METS 2019 – largest marine equipment show

Traditionally, from 19th to 21th November we would like to invite you to Amsterdam for the largest marine equipment and accessories trade fair (Marine Equipment Trade Show) – METS.

We are waiting for you at the Polish Pavilion in hall 5, stand 05.271

Why METSTRADE?

The METSTRADE Show is the world’s largest marine equipment trade show and the only truly international B2B exhibition for the industry.

The show has served as a platform for innovation, market developments and networking since the launch in 1988. It is a show every professional in the marine industry cannot miss.

  • Perfect place to network and forge profitable business relationships
  • Broad range of showcased innovations and new products from 1,600 exhibitors
  • Unique B2B conference & seminar programme
  • Located in Amsterdam, one of the most beautiful cities in the world

See you at METS!

METS 2019 – largest marine equipment show

Also check

Our FAQ answers to frequently asked questions

Why are the streaks formed?

Possible causes

  • Wrong viscosity and spraying technique,
  • Failure to maintain proper evaporation time and thickness of layers,
  • Incorrect spraying pressure,
  • Too low temperature of varnish, surface or space ,
  • Wrong thinner or hardener.

How to prevent

  • Apply the right type of application method indicated by manufacturer,
  • Use working spray guns,
  • Both the object and material must have room temperature of 20ﹾC,
  • Apply correct proportion of base and hardener.

How to remove

  • Grinding and polishing,
  • Grinding and painting,

Why the epoxy filler does not harden?

Possible causes

  • Incorrect proportion of base and herdener,
  • Too low temperature of ambient and surface (less than 10ﹾC),
  • Mixing two components from two different manufacturers,

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
  • Use base and hardener from the same manufacturer

How to remove

  • The uncured mass requires complete removal from the surface.

Why the paint does not have the right flow?

Possible causes

  • No thinning, wrong thinner or wrong amount of thinner
  • Wrong type of roll or brush (wrong bristle lenght)
  • Applying too much or too Little paint,
  • During painting process temperature was too high or the air was too dry,
  • Incorrect preparation of too porous surface,
  • Incorrect proportion of thinner.

How to prevent

  • Use a brush/Toller suited to the type of surface or paint,
  • Use thinner which is dedicated to the type of application and paints
  • Use thinning proportions which was indicated by manufacturer,
  • Paint in right atmosphere conditions indicated by manufacturer,

How to remove

  • Grind, clean and paint again.
Wyjście
Przeiń na górę