Wyszukaj na stronie
Menu

One Side Wool Sea-Line Brayt

One side polishing wool made from 100% natural wool. Ideal for removing scratches and mates on large surfaces. This is ideal tool for polishing gelcoats, PU topcoats and lacquers.

The diameter of the applicator – 200 mm, mounting Velcro disc Ø 150 mm

SizeColorRecommended backing plateCode
∅ 200 mmwhite“Universal” backing plate – ∅150300006613
One Side Wool Sea-Line Brayt
  • Cut level = 10

Basic information

RECOMMENDED POLISH PASTErecommendedoptional
  • S0
  • S05
  • S07
  • S1
  • S1 PREMIUM

You have questions about the product - One Side Wool Sea-Line Brayt

    Also check

    Our FAQ answers to frequently asked questions

    Why the paint does not have the right flow?

    Possible causes

    • No thinning, wrong thinner or wrong amount of thinner
    • Wrong type of roll or brush (wrong bristle lenght)
    • Applying too much or too Little paint,
    • During painting process temperature was too high or the air was too dry,
    • Incorrect preparation of too porous surface,
    • Incorrect proportion of thinner.

    How to prevent

    • Use a brush/Toller suited to the type of surface or paint,
    • Use thinner which is dedicated to the type of application and paints
    • Use thinning proportions which was indicated by manufacturer,
    • Paint in right atmosphere conditions indicated by manufacturer,

    How to remove

    • Grind, clean and paint again.

    Why the resin does not harden?

    Possible causes

    • Too low temperature of ambitne,
    • Incorrect proportion of base and herdener,
    • Mixing two components from two different manufacturers

    How to prevent

    • Apply the correct proportions of components
    • Maintain steady temperature (around 20ﹾC) during whole hardening process,
    • Mix the products thoroughly and bleed the mixture.

    How to remove

    • The uncured mass requires complete removal from the surface.

    Why the epoxy filler does not harden?

    Possible causes

    • Incorrect proportion of base and herdener,
    • Too low temperature of ambient and surface (less than 10ﹾC),
    • Mixing two components from two different manufacturers,

    How to prevent

    • Apply the correct proportions of components
    • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
    • Use base and hardener from the same manufacturer

    How to remove

    • The uncured mass requires complete removal from the surface.
    Wyjście
    Przeiń na górę