Plastic cups (buckets) with lid

If the scratches are not deep, then we can renew the scratched side by polishing with Sea-Line polishing pastes. Above the waterline, when the scratches are not deep, the surface can be repaired with a DRY FAST gel coat filler. Deep scratches should be filled with epoxy filler (selected depending on the requirements of the scratched surface), painted with a primer and then painted with topcoat.

Possible causes

• Incorrect proportion of base and herdener,
• Too low temperature of ambient and surface (less than 10ﹾC),
• Mixing two components from two different manufacturers,

How to prevent

• Apply the correct proportions of components
• Maintain steady temperature (around 20ﹾC) during the whole hardening process,
• Use base and hardener from the same manufacturer

How to remove

• The uncured mass requires complete removal from the surface.

Possible causes

• No thinning, wrong thinner or wrong amount of thinner
• Wrong type of roll or brush (wrong bristle lenght)
• Applying too much or too Little paint,
• During painting process temperature was too high or the air was too dry,
• Incorrect preparation of too porous surface,
• Incorrect proportion of thinner.

How to prevent

• Use a brush/Toller suited to the type of surface or paint,
• Use thinner which is dedicated to the type of application and paints
• Use thinning proportions which was indicated by manufacturer,
• Paint in right atmosphere conditions indicated by manufacturer,

How to remove

• Grind, clean and paint again.