Wyszukaj na stronie

WE CANCEL OUR PARTICIPATION

We regret to inform you that we had to decide to cancel our participation in Wind and Water Boat Show in Warsaw due to the coronavirus.

We want to reduce the risk of infecting our employees and those of you who planned to visit us. Our decision is conditioned by concern for health and safety of all of us. If you have any questions about our products please contact us info@sea-line.eu or call us (+48) 94 35 316 79

Thank you for your understanding.

WE CANCEL OUR PARTICIPATION

Also check

Our FAQ answers to frequently asked questions

Why the resin does not harden?

Possible causes

  • Too low temperature of ambitne,
  • Incorrect proportion of base and herdener,
  • Mixing two components from two different manufacturers

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during whole hardening process,
  • Mix the products thoroughly and bleed the mixture.

How to remove

  • The uncured mass requires complete removal from the surface.

Can I use universal thinner?

We do not recommend using universal thinners. The use of a thinner with an unknown composition may result in loss of adhesion, lack of proper flow of paint and varnish defects.

Why despite the use of antifouing paint the bottom of the boat is overgrown?

Possible causes

  • Too thin layer of antifouling paint,
  • Choosing the wrong antifouling to type of a boat or yacht
  • Thinning of antifouling paint,
  • Incorrect surface preparation before antifouling application.

How to prevent

  • Apply the right layer thickness of paint indicated by manufacturer,
  • Choose antifouling dedicated to type of boat or yacht and suitable for the type of water,
  • Do not thin antifouling because of the risk of reducing effectiveness,
  • Careful surface preparations (grinding, clearing, degreasing),

How to remove

  • Wet grinding, apply new layers of antifouling paint.
  • Use C1 shell and fouling remover.
Wyjście
Przeiń na górę