Wyszukaj na stronie

NOVEMBER – Time for meetings

After a long break, November again becomes a meeting time for our industry. We are very pleased to invite you to visit the Warsaw Yacht Show on November 5-7 and METS Amsterdam on November 16-18.

The Warsaw event takes place for the fifth time and at that time it has gained the status of the largest yacht exhibition in Poland. It is intended for both hobbyists and professionals. It will be an opportunity to talk personally with representatives of the Sea-Line brand who will always be happy to advise you on technical issues, how and what to paint on the yacht, how to protect the hull against osmosis or fouling.

The METS Marine Equipment Trade Show is a B2B event that has been the largest event for the yacht equipment and accessories industry for many years. Traditionally, we offer free tickets for people from the industry. If you are interested, please send an e-mail to info@sea-line.eu

See you in Warsaw and Amsterdam!

NOVEMBER – Time for meetings

Also check

Our FAQ answers to frequently asked questions

Can I paint the bottom of the boat with polyurethane paint?

Yes, you can paint the bottom of the boat with polyurethane paint due to its high mechanical strength. We recommend this solution when the boat is not launched for a long time and is not exposed to fouling.

Why the epoxy filler does not harden?

Possible causes

  • Incorrect proportion of base and herdener,
  • Too low temperature of ambient and surface (less than 10ﹾC),
  • Mixing two components from two different manufacturers,

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
  • Use base and hardener from the same manufacturer

How to remove

  • The uncured mass requires complete removal from the surface.

Is it necessary to always sand the surface between application of two different products?

We recommend to always sand the surface between applying two different products to ensure uniform surface roughness and adhesion of subsequent layers. The sanded surface should also be cleaned and degreased.

Wyjście
Przeiń na górę