Wyszukaj na stronie

Fantastic work which won our competition

We would like to introduce you a winner of second edition of our competition, Mr Michał Hoffa and his fantastic work with motorboat “ŻARŁACZ”.

To made such a fantastic motorboat Mr Michał used:

  • Epoxy primer LIGHTPRIMER 5:1 with thinner for epoxy primers
  • Polyurethane 2:1 white and ecru colour
  • Cleaner

Below few photos of how it looked before and after using Sea-Line products.

Fantastic work which won our competition

Koniec Konkursu Sea Line

Koniec Konkursu Sea Line

Koniec Konkursu Sea Line

Also check

Our FAQ answers to frequently asked questions

Can I paint a boat, previously painted with 1 component paint, with polyurethane?

It is not recommended to apply 2K paints over 1K paints. 1K and 2K inks differ in their composition and properties, including hardness, chemical resistance and durability. 1K paints are one-component and dry by evaporating the solvent, while 2K paints are two-component and need to be cured by adding a hardener. Applying 2K paint over 1K paint can cause unpredictable chemical reactions and lead to undesirable effects such as dulling, chipping or flaking of the paint. Therefore, always use paints according to the manufacturer’s instructions and do not mix different types of paints. farby zgodnie z instrukcjami producenta i nie mieszać różnych rodzajów farb.

Do you have to paint the scratched side of the boat?

If the scratches are not deep, then we can renew the scratched side by polishing with Sea-Line polishing pastes. Above the waterline, when the scratches are not deep, the surface can be repaired with a DRY FAST gel coat filler. Deep scratches should be filled with epoxy filler (selected depending on the requirements of the scratched surface), painted with a primer and then painted with topcoat.

Why the epoxy filler does not harden?

Possible causes

  • Incorrect proportion of base and herdener,
  • Too low temperature of ambient and surface (less than 10ﹾC),
  • Mixing two components from two different manufacturers,

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
  • Use base and hardener from the same manufacturer

How to remove

  • The uncured mass requires complete removal from the surface.
Wyjście
Przeiń na górę