TDS SDS – epoxy primers and 1K primer

Possible causes

• Too short time for evaporation of the thinner,

How to prevent

• Maintain the right conditions for complete evaporation of the thinner,

How to remove

• Mat the surface, degrease and apply the paint according to the rule (right conditions and thinning proportions)
• Polish surface if needed.

Possible causes

• Too low temperature of ambitne,
• Incorrect proportion of base and herdener,
• Mixing two components from two different manufacturers

How to prevent

• Apply the correct proportions of components
• Maintain steady temperature (around 20ﹾC) during whole hardening process,
• Mix the products thoroughly and bleed the mixture.

How to remove

• The uncured mass requires complete removal from the surface.

There is a possibility of thinning antifouling, but we do not recommend this procedure due to the risk of reducing the effectiveness of the paint. If it is necessary to thin the antifouling paint, it is recommended to dilute it to a maximum of 0-5% (by volume).