Plastic cups (buckets) with lid

Possible causes

• Too short time for evaporation of the thinner,

How to prevent

• Maintain the right conditions for complete evaporation of the thinner,

How to remove

• Mat the surface, degrease and apply the paint according to the rule (right conditions and thinning proportions)
• Polish surface if needed.

Possible causes

• Incorrect proportion of base and herdener,
• Too low temperature of ambient and surface (less than 10ﹾC),
• Mixing two components from two different manufacturers,

How to prevent

• Apply the correct proportions of components
• Maintain steady temperature (around 20ﹾC) during the whole hardening process,
• Use base and hardener from the same manufacturer

How to remove

• The uncured mass requires complete removal from the surface.

Do not add more hardener, because after the base has cured, the remaining hardener will react with subsequent layers, which will be applied to the surface and cause defects. For the product to work properly, please follow the proportions given by the manufacturer.