Masking tape

High-quality masking tape characterized by very good adhesion on irregular surfaces, easy to remove without leave any adhesive residue.

Saturated paper backing makes tape compatible with most common paints and lacquers. Heat resistant up to 80⁰C. Backing: yellow saturated crepe paper, adhesive: rubber solvent based.

Size	Code
19 mm x 50 m	300000530
25 mm x 50 m	300000531
30 mm x 50 m	300000532
38 mm x 50 m	300000533
50 mm x 50 m	300000534

Also check

Masking tape – master “Aqua”
Painter’s tape – MASTER “AQUA is a waterproof, single-sided adhesive tape. It does not leave
Masking tape – master “Aqua”
Silver tape – Universal
Strong tape of universal application, of the width of 50mm and the length of 25
Silver tape – Universal

Our FAQ answers to frequently asked questions

Possible causes

Too thin layer of antifouling paint,
Choosing the wrong antifouling to type of a boat or yacht
Thinning of antifouling paint,
Incorrect surface preparation before antifouling application.

How to prevent

Apply the right layer thickness of paint indicated by manufacturer,
Choose antifouling dedicated to type of boat or yacht and suitable for the type of water,
Do not thin antifouling because of the risk of reducing effectiveness,
Careful surface preparations (grinding, clearing, degreasing),

How to remove

Wet grinding, apply new layers of antifouling paint.
Use C1 shell and fouling remover.

Possible causes

Wrong surface preparation,
Skipping the primer in the system application process,
Use of universal thinners or replacements ,
Paint incompatibility.

How to prevent

Correct surface preparation (grinding, clearing, degreasing),
Use primers which improve adhesion of paints,
Use thinners which are dedicated to each paints,
Use of paints which are compatible to each other.

How to remove

Grind, clean and paint again.

There is a possibility of thinning antifouling, but we do not recommend this procedure due to the risk of reducing the effectiveness of the paint. If it is necessary to thin the antifouling paint, it is recommended to dilute it to a maximum of 0-5% (by volume).