Wyszukaj na stronie

Modernization of the electrical network

On Monday, October 18, 2021 and Friday, October 22, 2021, modernization works of the electrical network will be carried out in the area where our headquarters is located. This work will result in electric power cuts. Due to the above, on these days, the execution of orders will be postponed to the next day. Please plan your orders keeping in mind the possible longer realisation time.

Communication by email and office phones may be limited. In urgent cases, please contact us at the following telephone numbers:

  • Sławek Kukielewski phone: +48 604 821 461
  • Marta Wieder-Pokorska phone: +48 604 807 476
  • Karol Szkutnik tel: +48 602 712 435

We apologize for the inconvenience and we ask for your understanding.

Modernization of the electrical network

Also check

Our FAQ answers to frequently asked questions

Is it necessary to always sand the surface between application of two different products?

We recommend to always sand the surface between applying two different products to ensure uniform surface roughness and adhesion of subsequent layers. The sanded surface should also be cleaned and degreased.

Why did the polyurethane topcoat become dull?

Possible causes

  • Too short time for evaporation of the thinner,

How to prevent

  • Maintain the right conditions for complete evaporation of the thinner,

How to remove

  • Mat the surface, degrease and apply the paint according to the rule (right conditions and thinning proportions)
  • Polish surface if needed.

Why the resin does not harden?

Possible causes

  • Too low temperature of ambitne,
  • Incorrect proportion of base and herdener,
  • Mixing two components from two different manufacturers

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during whole hardening process,
  • Mix the products thoroughly and bleed the mixture.

How to remove

  • The uncured mass requires complete removal from the surface.
Wyjście
Przeiń na górę