Linguaggio:

HOLOGRAM REMOVAL – POLISHING INSTRUCTION

Home » Polishing instructions » HOLOGRAM REMOVAL – POLISHING INSTRUCTION
Naprawa łodzi
HOLOGRAM REMOVAL – POLISHING INSTRUCTION

HOLOGRAM REMOVAL – POLISHING INSTRUCTION

USE:

SURFACE:

EFECT:

HOLOGRAM REMOVAL – POLISHING INSTRUCTION

polishing instruction

OTHERS POLISHING INSTRUCTION:
Practical advice:

Condividi:

Vedi anche
Altre discussioni in questa categoria

Le nostre FAQ
Risposte alle domande più frequenti

Why are the streaks formed?

Possible causes

  • Wrong viscosity and spraying technique,
  • Failure to maintain proper evaporation time and thickness of layers,
  • Incorrect spraying pressure,
  • Too low temperature of varnish, surface or space ,
  • Wrong thinner or hardener.

How to prevent

  • Apply the right type of application method indicated by manufacturer,
  • Use working spray guns,
  • Both the object and material must have room temperature of 20ﹾC,
  • Apply correct proportion of base and hardener.

How to remove

  • Grinding and polishing,
  • Grinding and painting,

Why the paint does not have the right flow?

Possible causes

  • No thinning, wrong thinner or wrong amount of thinner
  • Wrong type of roll or brush (wrong bristle lenght)
  • Applying too much or too Little paint,
  • During painting process temperature was too high or the air was too dry,
  • Incorrect preparation of too porous surface,
  • Incorrect proportion of thinner.

How to prevent

  • Use a brush/Toller suited to the type of surface or paint,
  • Use thinner which is dedicated to the type of application and paints
  • Use thinning proportions which was indicated by manufacturer,
  • Paint in right atmosphere conditions indicated by manufacturer,

How to remove

  • Grind, clean and paint again.

Why the resin does not harden?

Possible causes

  • Too low temperature of ambitne,
  • Incorrect proportion of base and herdener,
  • Mixing two components from two different manufacturers

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during whole hardening process,
  • Mix the products thoroughly and bleed the mixture.

How to remove

  • The uncured mass requires complete removal from the surface.
La nostra offerta
Familiarizzate con la nostra offerta di materiali e vernici per la costruzione di barche
Exit
Przewiń na górę