Language:

WE SWITCH S3 TO NEW VERSION. WHY?

Home » News and promotions » WE SWITCH S3 TO NEW VERSION. WHY?
Farby szkutnicze
WE SWITCH S3 TO NEW VERSION. WHY?

WE SWITCH S3 TO NEW VERSION. WHY?

Analyzing the most common use of S3 liquid so far we have come to the conclusion that our customers use it primarily to clean the surface after polishing, and for protection is preferable to use wax S4.
We concluded to modified S3 liquid to meet the needs of our customers and produced the next generation S3 FINISH CLEANER product.
The new S3 FINISH CLEANER:

– removes the remnants of polishing dust from the surface,

– allows check quality of the polished surface

– used as final step of the polishing process to significantly emphasize the gloss.

Does not contain silicone, teflon and fillers.
Used together with other Sea-Line polishing materials, gives excellent results on gelcoats and lacquered surfaces.

More information : S3 Finish Cleaner


Share:

See also
Other threads in this category

Our FAQ
Answers to frequently asked questions

Why did the polyurethane topcoat become dull?

Possible causes

  • Too short time for evaporation of the thinner,

How to prevent

  • Maintain the right conditions for complete evaporation of the thinner,

How to remove

  • Mat the surface, degrease and apply the paint according to the rule (right conditions and thinning proportions)
  • Polish surface if needed.

Why despite the use of antifouing paint the bottom of the boat is overgrown?

Possible causes

  • Too thin layer of antifouling paint,
  • Choosing the wrong antifouling to type of a boat or yacht
  • Thinning of antifouling paint,
  • Incorrect surface preparation before antifouling application.

How to prevent

  • Apply the right layer thickness of paint indicated by manufacturer,
  • Choose antifouling dedicated to type of boat or yacht and suitable for the type of water,
  • Do not thin antifouling because of the risk of reducing effectiveness,
  • Careful surface preparations (grinding, clearing, degreasing),

How to remove

  • Wet grinding, apply new layers of antifouling paint.
  • Use C1 shell and fouling remover.

Why the epoxy filler does not harden?

Possible causes

  • Incorrect proportion of base and herdener,
  • Too low temperature of ambient and surface (less than 10ﹾC),
  • Mixing two components from two different manufacturers,

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
  • Use base and hardener from the same manufacturer

How to remove

  • The uncured mass requires complete removal from the surface.
Our offer
Familiarize yourself with our offer of boatbuilding materials and paints
Exit
Przewiń na górę