Language:

Polyester spray filler

Home » Products » Fillers » Polyester spray filler
Szpachlówki i podkłady szkutnicze
Polyester spray filler


TypeGRP laminates, wood, steel, aluminum
PlaceAbove waterline
FunctionLarge surfaces
ApplicationSpray gun
ThinningYES – 0-10%
Pot file 20°C20 min
Hardening time 20°C3 h
Colorlight grey
Packcode
1 kg –

10 kg –

25 kg –

9071

7504

1192


Share:

Do you have any questions?
We will respond as soon as possible

Related products

from Polyester spray filler


See also
Other products in this category

Our FAQ
Answers to frequently asked questions

Why the paint does not have the right flow?

Possible causes

  • No thinning, wrong thinner or wrong amount of thinner
  • Wrong type of roll or brush (wrong bristle lenght)
  • Applying too much or too Little paint,
  • During painting process temperature was too high or the air was too dry,
  • Incorrect preparation of too porous surface,
  • Incorrect proportion of thinner.

How to prevent

  • Use a brush/Toller suited to the type of surface or paint,
  • Use thinner which is dedicated to the type of application and paints
  • Use thinning proportions which was indicated by manufacturer,
  • Paint in right atmosphere conditions indicated by manufacturer,

How to remove

  • Grind, clean and paint again.

Why the epoxy filler does not harden?

Possible causes

  • Incorrect proportion of base and herdener,
  • Too low temperature of ambient and surface (less than 10ﹾC),
  • Mixing two components from two different manufacturers,

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during the whole hardening process,
  • Use base and hardener from the same manufacturer

How to remove

  • The uncured mass requires complete removal from the surface.

Why the resin does not harden?

Possible causes

  • Too low temperature of ambitne,
  • Incorrect proportion of base and herdener,
  • Mixing two components from two different manufacturers

How to prevent

  • Apply the correct proportions of components
  • Maintain steady temperature (around 20ﹾC) during whole hardening process,
  • Mix the products thoroughly and bleed the mixture.

How to remove

  • The uncured mass requires complete removal from the surface.
Our offer
Familiarize yourself with our offer of boatbuilding materials and paints
Exit
Przewiń na górę